Post by SUGARSKIS on Jan 2, 2011 21:27:13 GMT -5
hi i have older 1978 skidoo citation it has 250 TWIN engine with a mikuni Carb its a bugger to start!!
I hope some one here can tell me why maybe?
Ok heres how it goes
i prime it once or twice pull it over and its flooded completely
i have to pull the crap out of it then sometimes it wont start at all..
But if i hold throttle half open when its cold not warm it will start ok on the second or third pull after one or two primes..
When its warmed up no problems just pull it over and its starts well!!
Whats the setting for the air screw?
and what should the c clip on the needle on the ringed groove be on?
any ideas?
thanks
SUGARSKIS
