Jiffy ICE AUGER Carb settings?

[JIFFY30]

Hi would anyone here know what the carb air mixture settings are on a Old Jiffy model 30?
thanks.

[sledrat]

Try 0ne turn out on each screw on side of the carb to start with..
Then warm it up good
then turn the Main mixture screw in
till you hear the motor change and run poorly stop as soon as you hear that change
then turn slowly the screw back out back out just till you start to hear the motor run crappy again stop!
Now turn the screw back in about quarter turn or less or till it runs smooth and responsive
to clean it up the revs
so it runs smooth under load!,,

hope this helps

or The first Screw 1 1/4 out from gently seated
the second bigger screw main mixture is 3/4 - 5/8 out from gently seated..

but still you will have to be adjusted when warm in or out slightly..

*ALSO I have had a Jiffy for over 20+ years and never not mixed

the gas less than 24:1 as it calls for ,,And it still runs very strong with
good compression bet ya a easy 1000 of holes 4ft thick it has done!

SO dont listen to other folks tell you 50:1 is ok to use in it unless

you want or like rebuilding it or wearing out in half the time...

Dont get me wrong 50:1 mixed gas will work in pinch but i wouldnt use it for long
like all season ,,,But for a few holes no biggy Jiffy builds a dam good
ice auger!

And the OLD Jiffy Model 30 Metal Top has to be about the best built ICE auger for the price!

[Jiffy30]

Thanks set the carb and it's good to go!